[Dub]

Hi does anybody know what size tread the hose on the detail tool takes. I know the quick release end  is 1/4" but looking for the valve size, or someone that sells them.

same as Image below
http://www.rotovacusa.com/images/westpak_SG_Detail_Tool.jpg

[John Kelly]

1/4 inch.

[Mike Halliday]

the thread that screws into the valve of the handtool is smaller than the thread on the QR at the oppisite end (but  its the same on a wand valve)

If bud is correct that the QR is 1/4" then the valve must be smaller

this picture might show the difference

[John Kelly]

Sorry, 1/4" connect side, 1/8" at valve side.

[tony harrison]

Mike,

That valve which is on the QR coupling looks interesting ( small ) where do you get them from ?.

Regards Tony.

[Dub]

( Thanks  all )    1/8  NPT  it shall be ...