Wow, 650 ltrs used up by 12.52pm. What flow do you work on?
Do you usually finish all the tank by the end of the day?
I must admit i use more water hot than I did cold, but Ive not drained the tank. Lol ive come close to doing so though. But I find if i work on a lower flow I dont keep the higher heat at the brush end.
What temp did you get the tank to in the end?
not sure as I have sealed the lid some time ago as it was leaking.
I have a digital thermometer on the way so I can drop the sensor in the tank. It was warm at best, could feel warm through the hose and in the van too.
I had the heater on from 5pm-7pm. then 1am-3am then 4am-6am then 7am-9am. in 650ltr.
Today I would normally use 450-500 ltr. by midday I could tell I had used more than normal and was close to home so I topped up just in-case. I reckon I have used 650ltr today altogether.
The first half of the day was worst, then I turned flow down to accommodate the heat and things levelled out.
I started the day with a14" with 4x2mm jets but wasn't satisfied with the flow so I switched to a tucker 12" on pencil jets but the pencils in the tucker must 1mm or something similar and the flow was way too aggressive. I switched it to the fan jets that are already installed in the tucker along side the pencils and turned the flow down a little so saved some water as I decided to rinse on and go back later to check the results(which were pretty good but not perfect).