[Russ Chadd]

I tried some out on a domestic job, carpet was a standard polyprop... I found using my TM5 produced the best results as this lifted the pile as well as all the human and pet hair... Even after a good ore vac with the kirby.
Low profile carpets would benefit more from a rotary, Solutions now stock a rather good green MF with blue agitation strips which work very well.

Not sure you could do a comparison with DF as I'm not sure DF is strictly an encap product? 

[Paul Moss]

Wait till you try it with the orbot , now that machine does liftbthe pile

[Warren Aldridge]

Iv'e ordered some for a commercial tomorrow instead of Surround. Hope the endorsements aren't some BS sales patter. I would imagine because its UK made there is some more margin in it and a few more connections

[Steve Gunn]

Radio station coffee stain

[dan paton]

I tried some out on a domestic job, carpet was a standard polyprop... I found using my TM5 produced the best results as this lifted the pile as well as all the human and pet hair... Even after a good ore vac with the kirby.
Low profile carpets would benefit more from a rotary, Solutions now stock a rather good green MF with blue agitation strips which work very well.

Not sure you could do a comparison with DF as I'm not sure DF is strictly an encap product? 

russ on a domestic how does it compare to the likes of powerburst or shockwave

[Steve Gunn]

I tried some out on a domestic job, carpet was a standard polyprop... I found using my TM5 produced the best results as this lifted the pile as well as all the human and pet hair... Even after a good ore vac with the kirby.
Low profile carpets would benefit more from a rotary, Solutions now stock a rather good green MF with blue agitation strips which work very well.

Not sure you could do a comparison with DF as I'm not sure DF is strictly an encap product? 

russ on a domestic how does it compare to the likes of powerburst or shockwave

On domestics it doesn't perform as well in my opinion unless you hwe but it works out expensive to use it like that

[Warren Aldridge]

What mix did you put down on that stain?

1 -10 or 1 - 4 ?

[Steve Gunn]

1-10 mix

[Stephen Linton]

Is this a new product? How does it stand up to existing encaps? I must say the videos look impressive.

[Russ Chadd]

Dan

I only used it for encapping so i couldnt tell you if it stands up against powerburst or shockwave... remember this has a PH of about 6 which is slightly on the acidic side of the scale which is unusual... i spilt some on by table the other day.. it looks almost like its oil based.

[Jamie Pearson]

Peroxide boosted products need to be on the acid side of the ph scale to allow the compatible polymer to work effectively.