[A & J Owen Window Cleaning]

just cranked me new ro system and it working great the only thing thats a problem is that the tds reading is the same as from the tap whitch is 320  i have purged the system any advice i have followed the instructions correctly cheers mates

[Smudger]

Not an expert here and depends on the system but have you left the flush valve open?

and are you checking the pure or the waste ??   i only say this as the 1st system i had i used the waste not realising the tiny trickle coming out the other pipe was pure and the fast flowing pipe was waste!   

Darran

[ccmids]

just cranked me new ro system and it working great the only thing thats a problem is that the tds reading is the same as from the tap whitch is 320  i have purged the system any advice i have followed the instructions correctly cheers mates

you got a 4040 ro

[Window Washers]

needs to be flushed for hours, and what ever you do, do not connect to the resin  as will cost a small fortune, few hours then test,

[ccmids]

shut the waste tap then turn it anti clockwise 1/4 turn then test if no good turn another1/4 then test so on .
DO NOT  shut the waste tap tight just till you feel it touch .

[A & J Owen Window Cleaning]

yeh i will try that the flow pipe a bit tricky how long does the pure water come through then

[ccmids]

a few minutes

[A & J Owen Window Cleaning]

will crank it up again in a sec i hear some where online there was a chemical u can use to bring the tds reading down to 2 any advice mate

[ccmids]

never herd that one , if you have the water on full max presure , the water should be going in the tank at around 6/7 tds . then when you get to the job it goes through the di to the hose.

tap/pre filters/RO/tank.   that order then............... tank/di/hose.

[NWH]

Makesure you have it plumbed in the right way round,you could have the waste water going in the tank that`s why  it looks like you have a high  reading.It dosen`t have to be flushed that long before the reading comes down.

[A & J Owen Window Cleaning]

plumbed in ok orange hose waste and blue pure aint it

[NWH]

plumbed in ok orange hose waste and blue pure aint it

Who know`s,the colour of you hoses means nothing to me i`m afraid it needs to be plumbed in correctly so tht the good water is going into the tank and the waste water is going down the drain "simples".

[A & J Owen Window Cleaning]

its plumbed in ok m8 who does cheap baffle tank do you know

[ccmids]

is it working now

[stevehinnis]

Check your di tube.Carefully unscew it and see if it is not damaged.Mine was when I got it last week.
If there isnt a perfect seal your reading wont be 00.
Steve.

[A & J Owen Window Cleaning]

have tried all these still the same run it today for 2hrs gettin peed off with it now still 330 tds tried flow tap shut and open and just betwen