Morning all,
Last week we were called out to look at 2 carpets in a small retail development. The carpets are in two separate units at the same location, but basically independent apart from the fact they are suffering from the same problems.
The carpet is a bitumen backed nylon tile and with the way it reacts to hot drink spillages i would say its been dye blocked. Its resin bonded directly to a poured concrete floor.
In both units there is a door that doesn't seal properly and water ingress is visible. In the unit i have the pictures of, the sub-floor was still wet when we arrived. I would expect the other unit to be the same, but it was a busy retail unit and i couldn't check. Similarly, both use the "initial" type of rubber backed matting that seems to be allowing the carpet to sweat.
Im wondering what is causing the red shifting of the dye?
Phase 1 of shifting >> water seepage under tile and typical black lines appear of what look like soil from a water spillage. They are not removable and therefore i don't think they are soil lines.
Phase 2 of shifting is that the colour of the carpet is moved to the red region. Typical of a bleaching effect.
Picture 3 is an example of the the area.
Any ideas?
Graeme
Access cleaning Solutions