[drive surgeon]

New Surface Cleaner with Gum remover

June 02, 2008



 
 
As we are already well known in the Surface Cleaner market, we would like to present the “New Star” in our Surface Cleaner Line. The “FL-AH-KAU”. It is based on the FL-AH Surface Cleaner with an added gum remover.

You may have noticed a lot of streets in public places, like municipal parks, railroad stations and schools are covered with chewing gum. This is the perfect place to use our new cleaner with the gum remover. The special gum remover nozzle is mounted on the back of the cleaner. The right hand side gun is for the surface cleaner and the left hand side gun is for the gum remover or other tough spots. The flat angle of the nozzle lifts the gum for easy removal.

Additional Features:
- Air recovery
- height adjustable
- stainless steel swivel



anyone think this willbe good??

[mark.laycock1@ntlw]

where can i see the photo of this?

[drive surgeon]

www.mosmatic.com, cheers mark

[BDCS]

Personally I think the only thing that really removes hardened gum is heat so the second trigger would have to be fed from a hot machine, It looks a bit over the top and Americanised for me but I no doubt it will appeal some

[mark.laycock1@ntlw]

the graffiti surface cleaner looks good where can i get one of them from?

[drive surgeon]

well you could run it off a hot washer and just clean the surface and remove the gum at once, i was thinking of getting rid of the cold washer as a hot washer is better for removing oil, gum, and graffiti so they are miles better than cold arent they?  it gives you more scope.

[drive surgeon]

jetwashdirect,co.uk   

[mark.laycock1@ntlw]

thank you

[TVCS]

I have used jetwash direct before now and they were really helpful and really quick with the old delivery.

[drive surgeon]

its £1400 so its a bit steep, you need hot water too but im not sure how effective it will be?, does hot water water thru a whirlaway  remove chewy?

[trevor perry]

sorry drive surgeon hot water through a whirlaway wont move the gum you need to go over each piece with a normal lance and jet.