This is an advertisement
Interested In Advertising? | Contact Us Here

Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

rb4no

  • Posts: 229
fsc help
« on: June 24, 2024, 06:53:09 pm »
hi guys, recently refurbished my fsc with new bearings and out everything back how it was dismantled. Thing is that it didn't spin as freely as before and actually stopped whilst I working with it? I've since dismantled it and can't see a problem. The fsc is fro jetmac but the spinney bit looks very generic and looks like many others out there.  Any thoughts?

Smudger

  • Posts: 13428
Re: fsc help
« Reply #1 on: June 25, 2024, 11:09:04 pm »
What bearing did you get - cheap bearing can cause issues as in size and tolerances

Did you grease it well and use the correct spec ?
Never argue with an idiot, they will only bring you down to their level, and beat you with experience

rb4no

  • Posts: 229
Re: fsc help
« Reply #2 on: July 01, 2024, 12:59:01 pm »
Yes went to a bearing specialist in Norwich and got like for like.

Smudger

  • Posts: 13428
Re: fsc help
« Reply #3 on: July 01, 2024, 04:09:27 pm »
Norwich !

oh dear  :(

they only deal with trac-tors boy!
Never argue with an idiot, they will only bring you down to their level, and beat you with experience

Smudger

  • Posts: 13428
Re: fsc help
« Reply #4 on: July 01, 2024, 04:11:27 pm »
when you dismantled it did the bearing run free at this point ?
Never argue with an idiot, they will only bring you down to their level, and beat you with experience

rb4no

  • Posts: 229
Re: fsc help
« Reply #5 on: July 03, 2024, 04:02:37 pm »
the first time I dismantled it the bearings were on there way out so got those replaced, been scratching around trying to figure whats' going on to no avail so bit the bullet and bought a new internal shaft section, I'll compare the two side by side to see what's wrong with the original  and then use it for spares I guess...

Smudger

  • Posts: 13428
Re: fsc help
« Reply #6 on: July 03, 2024, 11:15:01 pm »
so you haven't dismantled it since putting in the new bearings ?

if so, have you checked they still spin freely ?
Never argue with an idiot, they will only bring you down to their level, and beat you with experience