[cleaning4usussex]

i have just fitted my new system and don't know anything about them to be honest I plugged my hose onto the fill connection then I turned tap on all of a sudden water started coming out of a tap on the end of my ro I have turned this of as hard as I can and still happening ?? Do I need to add a pipe on this???
Jamie

[dave0123]

What system do you have is it a 4040 (40 inch membrane) type ro?

The outlet with the tap is your waste water if its a 4040 ro you slowly close this to start producing pure water but never close the tap fully as you need a constant flow of waste water and pure water.

[cleaning4usussex]

So do you pipe this out of the van a swell ? Jamie

[dave0123]

The pipe with the tap on needs to go down the drain its not be to used.

[cleaning4usussex]

Ok so I put the pipe on and put the other end down a drain how much do you open the tap? Sorry I have never done this before

[dave0123]

Well you never said if its 4040 (40 inch membrane) if it is you need to set it up with your tap pressure for best performance.

Close the tap a little bit so some pure water is coming through the pure pipe and then measure your Tds .. then close it a little more and measure your Tds level and repeat this untill you get your lowest TDS and that is your optimum setting. If you close it too much it will start to rise again.

[cleaning4usussex]

Thank you really appreciated been trying to upload a picture of it but it's not letting me its a 40 40 ro its a water genie 500ltr system from cleaning warehouses

[cleaning4usussex]

Got my house tap on full and got the reading 000 thank you dave