Hi guys,
Here is my gutter vac'ing nozzles for tackling almost any job.
Please note I currently use Ali poles and the system was cobbled together to suit omni vac poles, hopefully when we upgrade to carbon fibre I could produce something more professional
Problem number one is that omni vac use a very strange size tube, I could not source a suitable size in Ali and had to settle for stainless steel a bit heavier but the benefits of this system outweighs ( haha ) the extra weight
I added a section of tube to the 135 degree bend which allows standard 2 inch Ali tube to be inserted and clamped this allows for quick change nozzle ends
As you can see the crevice tool can be turned a full 360 degrees, which allows a far greater use of the tool in tight gutters and as importantly tight alleys and gardens.
The crevice tool is only 14 mm wide , less than the thickness of my fingers
Below is the range of nozzles I use from left to right ....
2 inch reducer to 38mm for dropping into down pipes
2 inch standard end cut at 45 degrees
2 inch serrated end - great for grass and weed turfs, dig in, turn and pull out
The teeth are approx 8mm long
Blue 45 degree 2 inch reduced to 32mm with 45 degree cut, a really useful end for use with or without the 135 degree bend - excellent when reaching over conny's or between pitches and for the gunk stuck under tiles
Black 90 degree for getting into corners or odd and unusual angles
Above the blue and black silicone nozzles is the gulper a great tool for clearing moss off car ports and conny roofs
Camera wise I use a bird box camera and fibreglass flag pole, the camera and receiver cost around 70 quid from
www.cctvspycameras.comThe flagpole is 33 ft and telescopic
Hope this helps
Darran
