This is an advertisementInterested In Advertising? | Contact Us Here
Nice one well done .So you have a wife and kids Seriously it's very good on you to show everyone this , well done .Getting a ford galaxy plastic boot liner for my transit van . Where you get them silver pole holders/clamps I use hooks like you have
Fantastic videos D, given me some great ideas that's for sure. Cheers.
Took me ages to sort out, so will show you what i can remember....Plastic 1" female X 1" male thread elbow ( http://www.cleaningspot.co.uk/acatalog/Plastic_fittings.html )I then wedged on the yellow hose and used two jubilee clips.Make sure you use plastic washers on top, rubber below.Then something like this in the lidhttp://www.screwfix.com/p/straight-tank-connector-21-5mm-pack-of-5/11877You will see in the lid i had a white fitting ^ That similar BUT the wrong size.If you aint fused on maximum flow, then i would just fit something like this...........http://www.screwfix.com/p/bent-tank-connector-21-5mm-pack-of-5/11326Best bet is do what i did, i got everything i needed, went to local plumbers and they matched it all up. The above will put you on the right lines
No hose inside the tank. 25mm conduit. It gets rammed into the white fitting. Conduit down to bottom of tank then piece of hose from conduit to bilge pump barbed fitting. They key is to use 25mm 1inch fittings if you can.
brilliant videos , pretty much all good ideas i had but lack of time please could you tell me :where you got the led lights from ?van mat ? i have looked but my internet understanding is very limited. many thanks