[james nicholson]

Ok so i was upgrading ro extra housing and new membranes heres the problem both the waste and pure lines were flowing when i flushed it when i finished flushing and set it to produce both waste and pure are coming out at same speed (very fast) and high tds 220 on both i followed the diagram i was sent checked and re checked before i did it was so sure it was right any advice please

[Don Kee]

You might need a new flow restrictor if you've added membranes

[james nicholson]

I spoke to pure freedom about this before i did it and they said the use same flow restrictor on all their ro systems 200gpd to 450 gpd do you think that could cause this problem gonna go through it all again later im wondering if i have got the pure and the waste from last membrane wrong way round

[Spruce]

I spoke to pure freedom about this before i did it and they said the use same flow restrictor on all their ro systems 200gpd to 450 gpd do you think that could cause this problem gonna go through it all again later im wondering if i have got the pure and the waste from last membrane wrong way round

When I first read your problem, my thought was you had the membrane plumbed in incorrectly.

[james nicholson]

i think it may have been that took it all apart and re started and all good now and a lot faster water production to boot