Toggle navigation
Home
Help
Search
Register
Login
1 Hour
1 Day
1 Week
1 Month
Forever
Clean It Up
UK Floor Cleaning Forum
Carpet Cleaning Forum
parts required for a bypass valve
Interested In Advertising? | Contact Us Here
Warning!
Welcome to
Clean It Up
; the UK`s largest cleaning forum with over 34,000 members
Please
login
or
register
to post and reply to topics.
Forgot your password? Click here
« previous
next »
Login
Register
Print
Pages: [
1
]
Russ Chadd
Cleanitup God
Posts:
1261
parts required for a bypass valve
«
on:
December 15, 2012, 07:50:23 pm »
I am looking to build several bypass valves and fit them to my tools, can anyone suggest where to buy the required parts featured in this video?
http://youtu.be/ShCCnbLR9Qs
Logged
www.prosteamuk.com
Carpet Dawg
Cleanitup God
Posts:
2968
Re: parts required for a bypass valve
«
Reply #1 on:
December 15, 2012, 07:55:58 pm »
hydramaster sell them no? or similar
Logged
Mike Halliday
Cleanitup Global Moderator
Cleanitup God
Posts:
11578
Re: parts required for a bypass valve
«
Reply #2 on:
December 15, 2012, 08:00:08 pm »
All them parts are quite freely available from any hydrolics or compressed air stockist, the only difficulty will be tapping into the wand.
I would suggest using compressed Airfitting as they are cheaper and less bulky, but only rated upto about 600psi
Logged
Mike Halliday.
www.henryhalliday.co.uk
Mike Halliday
Cleanitup Global Moderator
Cleanitup God
Posts:
11578
Re: parts required for a bypass valve
«
Reply #3 on:
December 15, 2012, 08:10:24 pm »
You can do it easier than Robs example but fitting an inline 3 port valve and getting a hydrolics supplier to make you a small solution line with crimped elbows.
This will also make the bypass less prone to damage if you bash it or drop your wand.
This is an example of a 3 port valve but you will need to find a smaller one (which are available)
http://www.ebay.co.uk/itm/HYDRAULIC-3-WAY-HIGH-PRESSURE-HP-BALL-VALVE-3-8-BSP-35LPM-500BAR-T-PORTED-/251189535790?pt=LH_DefaultDomain_3&hash=item3a7c10242e
Logged
Mike Halliday.
www.henryhalliday.co.uk
Russ Chadd
Cleanitup God
Posts:
1261
Re: parts required for a bypass valve
«
Reply #4 on:
December 15, 2012, 08:10:56 pm »
To be honest Mike 600 psi is plenty, i have located a welding shop who can weld the stainless steel pipe, just need to find fitting which are compact.
Logged
www.prosteamuk.com
Russ Chadd
Cleanitup God
Posts:
1261
Re: parts required for a bypass valve
«
Reply #5 on:
December 16, 2012, 03:09:07 pm »
Can anyone confirm the type of thread used in carpet cleaning fittings?
Im not sure BSP is right, as i recall i tried to use a BSP 1/4 male to male nipple once an it was wrong.
Would the thread type be NPT?
Logged
www.prosteamuk.com
Login
Register
Print
Pages: [
1
]
« previous
next »
Clean It Up
UK Floor Cleaning Forum
Carpet Cleaning Forum
parts required for a bypass valve