[Russ Chadd]

Can anyone tell me the correct mixing / dilution of Enz - All if used in a hydroforce which is set to 9:1, this is the info i lifter from the website :

pH @ use: 11.5 - 12.5

Coverage: Up to 200 square metres per 42g

Dilution: 1 scoop to 4L hot water. T/M 10 scoops to 4L water

Appearance: Off-white powder

Fragrance: Floral

Packaging: 1 x 2.5kg (case of 4)

[Nigel_W]

Russ,

If the normal dilution is 1 scoop to 4 litres  of hot water then you would just add 9 scoops to 4 litres of water to make your stock for the hydroforce.

Nigel

ps if you want to fill the hydroforce full (eg 5 litres) add an extra 2.25 scoops for the extra litre.

[Russ Chadd]

Thanks Nigel

I am assuming a scoop is 15 mg ?

[Jamie Pearson]

43ml I think. It says on bottom of scoop.

[Russ Chadd]

It didnt come with a scoop so im a little lost!

[Jamie Pearson]

Tip it on its side and give it a good shake. The scoop should appear. In 20 years I have never heard of someone getting one without a scoop. If you have a blue prochem scoop 3 of them makes up 1 Chemspec scoop.

[Russ Chadd]

Haha.. cheers!

[Carpet Dawg]

I didn't get a scoop in a spray and go once  . Bought a pack of six. Used one from my formula 90

[Nick Attwood]

All Chemspec products when refering to a scoop, is there standard 43ml scoop. As Jamie said.