[ben M]

I have a streamline digital controller, my flow rate is 40.
Do you think is enough to rinse properly or should i increase it?
thanks

[Ian Sheppard]

There are far better people to answer this than I.

I would just say that the ideal flow rate is very much a personal opinion as it will depend on each system set up and each persons preference

a flow rate of 40 is not bad and will give you a reasonable amount of water at the brush head.

[dazmond]

60 on my digital pure freedom controller.sometimes 70-80 on dirty first cleans.40 would be too low on my system and it would take longer to do the job.

i use 100m of microbore.what hose do you use? as this will affect the flow.eg if you use minibore (8mm)hose your flow would probably be the same as mine if not a bit higher on 40!

[ben M]

60 on my digital pure freedom controller.sometimes 70-80 on dirty first cleans.40 would be too low on my system and it would take longer to do the job.

i use 100m of microbore.what hose do you use? as this will affect the flow.eg if you use minibore (8mm)hose your flow would probably be the same as mine if not a bit higher on 40!

i use 100m of microbore (8mm)

[bobplum]

i use 40 on maintenance cleans,50/60 on first cleans,i also use fan jets, whether that makes a difference or not

[Mo Al]

wow I use 9-18 and 25 is pushing the boat. Still get an excellent clean. Using Wintecs Controller.

[Cliff perkins]

I use around 15 to 18 daily and 20 for 1st cleans lol
So it shows you that every1 is diffrent need to judge for yourself if your rinsing the windows ok.
Just play with it untill u get where u wanna be.

[DeLuce]

I run 80m of microbore on a Liquid Logic controller, which is similar to yours and I have the setting on 42, I tried it on 20 but thought that the flow was not strong enough for me. Experimentation is the key until you find the best for you.

[dan hughes]

80m (ish) of minibore,

i use setting of 50/60 regular cleans small windows. First cleans, or big shop windows, i blast it up to 69/80. But i like full blast.
Still can't manage to change the cutoff settings. Tried and tried, they just end up ping me off,so i leave it as it is. Works fine enough.

I'm thinking that 20 would be a dribble.