[kaz and pete]

hi bought two clx poles from gardiner in april had a few niggly problems but the one pole where it extends out the stop has come off is there any one who knows how to fix this.  also one of the poles never seems to tighten up very well and tends to twizz round while i am trying to work can be a little annoying.  Can any one help with these two problems   

[Alex Gardiner]

I'm sure that we can 

Drop me an email on alex@agardiner.co.uk

[Window Washers]

I'm sure that we can 

Drop me an email on alex@agardiner.co.uk

Alex, quick question, have you had any issues with the pole screw attachment on brushes cracking the bit where you put to screws in to attach to the brush head.

[Alex Gardiner]

Not as far as I know - send me a photo to the above email and I will have a look for you.

[Pope vader]

i have,   i have had a few come out when using them,  just got to tighten them

[dazmond]

Simply take the section out and take off old tape.put one and a half wraps of new insulating tape on and gently slip it past the clamp on section its going in.adjust clamps for tightness when extended.any section that spins is usually worn if adjustment doesnt work.check the clamps though for thread/barrel damage.if so replace.

Its a 10 min job.


Dazmond

[Window Washers]

if it spins when closed maybe run on some aridite around the inch by clamp, wait to dry this will stop it spinning when closed, lasts a while, found this out by mistake when gluing a loose clamp.

[Dave Willis]

  What?