[Erithwc]

Hi

i need help dont know what i need to do what i want and if i just guess i know i will end up with bits i dont need.

what i want to do is have both fan jets and pencil jets on the same brush with push fitting so i can change over without any problems so i can decide which works best for me before i order a new brush

the red dots are where i was thinking of putting the fan jets



what i want is the same as this guy has done

http://www.youtube.com/watch?v=rxT68-W9XMI

thanks Paul

[Pope vader]

u will need 2 fan gets,  a new y piece, and piping,  12mm drill bit and drill

[Erithwc]

is this all i will need ?

Fan Jets Standard 40 degree            x2     
John Guest 8mm Equal Tee               x2     
John Guest 8mm stem to 6mm Barb  x6      

[Erithwc]

u will need 2 fan gets,  a new y piece, and piping,  12mm drill bit and drill

Hi

thanks for the reply but i wanted to do away with the y piece and have a push fit to make swapping over easy

thanks paul

[Pope vader]

ok just replace the y peice with a push fit

[lee_dewing]

If you slow the flow rate down on fan-jets, it omes out like pencil jets.