[Blackbushe Windows]

Flowmaster reading alternating between flow setting (27) and P5. Can't get it to run. Is this an error message, and if so what's gone wrong?

[Dave.]

PS means your pressure switch has kicked in and stopped the pump - If it reads DE your flow controller has detected a dead end and stopped the pump - it sounds like you need to either calibrate your flow controller to your hose and pump and/ or adjust your pressure switch (if it is adjustable).

Do you have any set up instuctions that came with your flow controller

hope that  helps

Dave

[Pope vader]

check all connections, mine does this when it comes lose

[Blackbushe Windows]

Dave,

Yes instructions (Quick start guide) only say "Pressure switch activated or motor disconnected". Pump goes deadend as usual when tap turned off on hose, but soon goes to P5. Only way to resume water flow is to tap pump. Ive not changed anything I'm doing.

Peter

[Blackbushe Windows]

Sorry, yes also have setup for Autocal?

[Blackbushe Windows]

Which connections can cause problems?

[Pope vader]

all of them, u only need one to be lose form the pump

[landy2]

just disconect your controler from the battery and it should go back to normal

[Blackbushe Windows]

Have re-setup autocal to 30. Seems to be ok. Is this setting right?

[matthewprice]

i get this if there is any air in the pump eg water below tank outlet or as said any even  a connection just a little loose

[Blackbushe Windows]

Won't know if resolved till Tuesday, but looking hopeful.

Thanks for your suggestions - will remember tips for future ref.

Peter