[Adam Fearnley]

get an inline kettle 

[Jamie Lindsay]

old fashioned hot water tap 

[M.Acorn]

I def won`t be replacing with a Prochem again,this is my 2nd,in 7 years,the last one is prob just out of warranty too,going to see it a can cut the thread down a bit,it`s leaking because part of the thread has broken off,so the nipple inside the swivel is not sealing it properly,it was a little trickle to start with,but that has escalated to about a pint out of every 40ltrs i put in machine  :

[Jamie Lindsay]

those heaters seam more hassle than there worth

[Steve. Taylor]

Mark you can fix these easy when they split there new thread silver solder to the old one.
If you want any advice on it let me know will go through it with you on the phone. cost to repair under a fiver

[M.Acorn]

It`s just very top,prob 1 thread thickness ,like if you had put needle nose pliers on it an nipped a little chunk out ,was just going to try and either file it flat,or hacksaw it flat,gotta be really careful though,as i know it`s just a short bit of copper pipe that goes into the jacket,very fragile,the last 1 was leaking from the water container bit last time,the travelling up the inside to the electrics.
I did hear talk about another in line that was supposed to be good