[bobplum]

can i use the system if the ppm is 10 maybe 9
all new filters and resin installed so not much more i can do
all advice welcom
bob

[darren clarke]

u should be fine with that, or u can put a di vessel after ro to get it down to 000

[bad trippy]

Who did you buy the RO from?

[bobplum]

i bought second hand on flea bay,replaced all the filters and it does have a di vessel after the ro machine
may get a second di
many thanks
bob

[darren clarke]

try using a di vessel in van

[Frankybadboy]

i say before you do any more spending take all apart and try re-seating all the filters again.

check all rubber seals are ok and not kink,



did you flush???

[bobplum]

 i have flushed for about 30 mins it went from 115 to 10 and as stayed at that level if i can use the water at that level i will for now and purchase a second di in the coming weeks and install in the van

my concern was "can i use the water at that ppm"
bob

[Frankybadboy]

what ro is it???

[bad trippy]

Bob 10 should be ok but it would be nice if you can get 0.
As Franky says, unscrew all fliters and check they are all ok.
Take a reading of the water after RO only, if its coming out at 10 then the trouble is with the di vessel.
I had this prob a couple weeks back, it kept coming out at 13 after DI, stupid me screwed the cylinder the wrong way round ie it was upside down

[bobplum]

what ro is it???

PURE FREEDOM 100 GPD
BOB

[Sunshine/Cleaning]

can i use the system if the ppm is 10 maybe 9
all new filters and resin installed so not much more i can do
all advice welcom
bob

The resin should get it down to 000ppm if not get a bigger resin vessel.

Test the ppm after RO but before resin.

[bobplum]

can i use the system if the ppm is 10 maybe 9
all new filters and resin installed so not much more i can do
all advice welcom
bob

The resin should get it down to 000ppm if not get a bigger resin vessel.

Test the ppm after RO but before resin.

came out as 20 from the ro down to 7 from the di
bob

[mileslake]

I bought a P F system,    always at 000 after I change resin and when it was new.

[Blue Frog Systems]

Needs new resin.... 007 is ok to use. Just changed mine over and it was at 011.

Order some new resin in the morning.  Twin di vessels will save you £££.

Since using twin di, my resin change has gone from 2 weeks to 3 & 1/2

[bobplum]

thanks everyone
second di it will be
bob

[A & J Owen Window Cleaning]

bob mate what vessels do you have installed and check tap reading sometime they fluctuate in winter i have a 25 ltr vessell hooked up to a 16 ltr and a carbon filter tis lasts 4 mths on constant usage just replaces resin in both changed to tulsion resin never tried this before