[gwrightson]

Stacks of room in the master for t/m  and loads of other gear and as already stated by Simon the low floor makes it a doddle to load and unload, My honda pressure washer I previously had to use ramps on with a sprinter , now its a case of just lifting on to edge of van and loading straight in.

The only drawback with the master imo is the limited turning circle compared to a sprinter.

geoff

[Tom Bennett]

Richard,
Is that a standard sized reel, I looked at putting my reel over the wheel arch  but mine appears to be wider than yours.
I've the same van as yourself and the extra room would be more than useful.
What length of hose do you carry (on photos)

[richy27]

Richard,
Is that a standard sized reel, I looked at putting my reel over the wheel arch  but mine appears to be wider than yours.
I've the same van as yourself and the extra room would be more than useful.
What length of hose do you carry (on photos)

tom

just a standard reel from woodbridge had a solution reel on the side but cut it off along with the live port to reduce the width. mounted the sol reel on the bulkhead on a stainless steel plate. obviously you need to extend wheel arch boxing to fit reel. i carry 200ft normally

if you want a custom hose reel hydramaster will do them for you so i believe.

rich

[Tom Bennett]

Richard,
Mine was from Hydamaster but yours looks narrower than mine, must be the photograph.

[Tony Gill Carpet Smart]

Renault Master for me LWB Medium roof brilliant van.

Tony

[murky]

Just a slight warning, the people I bought my tranny and TM from had there ramp hanging from their nearside rear door as well just like you and in the end the hinges went because of the constant weight and bouncing around.

Murky

[Oneills onb]

Richard where did you get that racking from

[richy27]

Richard where did you get that racking from

built the racking myself but it fitted the previous van only temp till i get the timeto build a new one to fit the ne van