This is an advertisement
Interested In Advertising? | Contact Us Here

Warning!

 

Welcome to Clean It Up; the UK`s largest cleaning forum with over 34,000 members

 

Please login or register to post and reply to topics.      

 

Forgot your password? Click here

Pages: [1]

pauld

  • Posts: 57
Aqua adapter not turning on of
« on: September 04, 2014, 03:16:06 pm »
The 4 prong wheel ( on of switch ) on My aqua adapter has started to get caught on the trigger , stoping it from turning on and of .
I tried taking out trigger and cleaning it wich worked for a week but now it has started again and cleaning trigger doesn,t rectify it.
it is only a couple of months old.
Any advice greatly appreciated.
Logged

Smudger

  • Posts: 13459
Re: Aqua adapter not turning on of
« Reply #1 on: September 04, 2014, 04:49:59 pm »
Dirt in the spring at the side ( or broken ) that pulls the striker back up after the 'tap' has gone past.

The other thing could be the carriage has some dirt in it, making it a little tight and not turning the tap fully when pulled, washout with pure then spray with some PTFE spray until nice and loose

Darran
Logged
Never argue with an idiot, they will only bring you down to their level, and beat you with experience

J.D

  • Posts: 636
Re: Aqua adapter not turning on of
« Reply #2 on: September 04, 2014, 05:19:04 pm »
This isn't as silly as it sounds! Put the whole adapter in a basin of warm soapy water and give it a good scrubbing with a dish washing brush. Rinse and shake dry then reattach ! In the unlikely event that it doesn't work then pull the flywheel off and clean and replace. They click off and on easy enough.
Logged
Pages: [1]