[john martin]

And its the cost which then kind of forces you to consider the new breed of 5.7 motors which Alltec and Ashbys are using for their series machines.
So far (touch wood) my machines have been fine.
Anyway... might  still be up for bringing a machine or two to the TACCA event, Are you joining us this year John?

This is the lowest price iv seen for 240v  ...  but they dont ship to outside the US  , so would have to send to post forwarding company ... I think it was about $100 to ship two but i'd have to look it up again ... adding tax  you could have them 200- 250   not bad , must look into it more . 
http://www.zorotools.com/g/00008577/k-122178-18/

Id expect you'd see no lift increase over you Enforcer three stage  , perhaps even a small decrease but you would gain 20- 30 perhaps more cfm at a guess , which might be significant in series .

[Steve Fortt]

When and where is the TACCA Day being held this year?

Is it ticket only, or can you pay on the day?

Steve

[dan paton]

All the info here Steve
http://www.tacca.co.uk/article/tacca-2014-training-day-open-saturday-june-7th-2014/

[Steve Fortt]

Excellent. 

Thanks Dan.

[Rob_Mac]

Derek

Would you like a pressure washing van there?

Rob

[derek west]

Not sure yet rob, its a numbers game and i have to get the balance right, we've got new trainers this year, Derek Bolton, Julie Roberts, terry Guilford, Gavin finch, Judy bass and Paul Pearce, and then we have last years trainers John kelly, Mike Philbin, Jamie Pearson, Dave Althomstone Richard Sudall. So their is a lot going on. If we sell enough tickets then who knows, certainly not ruled it out as yet.

[jim mca]

Need to make it 2 days then could not possibly fit all that in and eat a hog in day