[Avo]

Why is it that they become almost impossible to change brushes over.. "New" they work smooth but 1 month later there very stiff to take apart.. 

[simonr]

i've got 1 brush that is fine on 1 pole but a nightmare on the other, i dont push it full on & its still dead hard to get off   

alex

[PoleKing]

WD40 methinks...

[Avo]

Should be called slow loc not quick loc  drives me nuts.
Yes I stopped pushing it all the way on as well haha
It's like the plastic swells up 

[Simon Spencer]

Yep same here, I put some Vaseline on the angle crank end and its still hard to pull off.

[ben M]

quick release apparently,i took me 10 min last time 

[Avo]

quick release apparently,i took me 10 min last time 

i no ha ha jammed on really annoying thou, it's faster on the threaded type unscrewing it

[gto]

mine has never been out, as its jammed solid from new.

[Alex Gardiner]

It could be that the plastic has swelled slightly with the warmer weather - nylon does vary with ambient conditions.

A little lubrication may well be all that is needed.

Of course if it is a problem and even lubricating this does not make it run smoothly then please contact the office (01726 66400) with your order number and we can rectify this for you.

[brianbarber]

Funny, just had this today, hadn't had to remove brush since new, bout 6 weeks, had to push ball bearing in and tap off with a hammer...


Mr B

[windowswashed]

If the ball joint sticks making it hard to dissemble after some use, .......what's the chances of the ball socket springing out of the housing like some Schrader pole connections do after much use when they fall to pieces? Was interested in the quick loc style but the comments on here have put me off now.