[john rees]

my glides came this morning,but what I need to know is how to fit them should the holes be flush with the original steel lips on the wand? as mine seems to have a half inch gap either end of the wand as if it needs trimming to fit flush! thought i'd better ask before I got adjusting
               thanks
                          John

[carpet_care]

John as long as the open vac slot is covered by the teflon glide i dont think it really matters also if you have told them exactly what type of wand you have i am sure they will have given you the right length.

        Regards Andy Locke

[john rees]

hi andy
           yes they knew which wand it was for,but if you look at the wand from the side there is about a half inch gap so it looks as if it will draw more air in that way than through the holes?

[carpet_care]

John i think you will find wants you slide it on it fits like a glove and there is no room for airflow at the sides.

  apologies if you try it and i am wrong but then again it shouldn.t prove too difficult to slide back off.

      Regards Andy locke.

[john rees]

thanks! I'll have a go!

[john rees]

hi andy! all sorted now.......it woudn't slide on because it was a prochem 11" wand with side shields on it so they were in the way and so stopping it being slid on but not to worry they fit another wand I have fine! they must have sent the wrong glides!
                 thanks
                           John

[Glynn]

Which wand do you have ?
and which glide (no) was sent to you ?

[john rees]

I have a prochem 11" 4 jet  wand that I was going to put the glides on but they have fitted on a 12" cmp wand instead, never mind I have lips to fit on the prochem wand now! so i'll try them out too.