[drive surgeon]

hi guys, ususally i use a small fsc on decking but im quoting a massive area of decking that is like an ice rink when you stand on it, can i use the big whirlaway on it at full bore or would i be best with smaller one with less pressure?  could i turn down revs on machine?

[mark.laycock1@ntlw]

hi, i use one without the caster wheels.and i turn down the revs of my machine down.and then sweep over with the fan jet.

[Blue Sky 2]

Hi,

On dirty decking I always use the Tec Clean fsc and then go over with the small wall cleaner.
All on full power. It can make the timber feather a bit but the finish is very good.

[drive surgeon]

think it will be ok on full myself as it will give uniform finish.

[steve_doyle]

I use the tech clean set up at 2/3 to 3/4 pressure. no probs but have splintered old decking at full power.

just start low and you can always increase it if required.

[trevor perry]

it would be best if you can use hot water at a lower pressure but if you only have cold then i would sugest treating the area first with a algae remover and then going over with the fsc but using bigger jets this way you will still have the water flow but the pressure wont damage the wood.

[drive surgeon]

cheers trev!

[mark.laycock1@ntlw]

hi,
will the hot water do anything to the grass and plants.

[steve_doyle]

it will make them lovely and warm!





well some one was going too!! 

[trevor perry]

hi,
will the hot water do anything to the grass and plants.

the water itself wont do any harm but if you leave the hot pressure hose trailing along a lawn then it can burn the grass.

[drive surgeon]

dont worry just using cold water this time.