[carpetfitta]

my lords and ladies of the empire,

only two problems cropped up this week, my 2 ramjet wand is now one roger ramjetless, one has stopped working...possible blockage? 
                                                  AND
my one and only upholstery tool now permanently squirts  solution at me, as soon as i turn the pump on? 

is there somewhere/someone who can save my sanity?   although i am frugal with the spondoolies, cost is not an issue in this case. a feasible solution is what i seek!   parts acquisition/suppliers/DIY advice/professional servicing???

regards baldrick x

[daysdeepclean]

First of all... It's all about confidence! And the right spanner,screw driver and whatever tool you're gonna need!
But you're gona need a good set of tools mate.... The rest is........ Common sense!

We'll help you matey! It's what us C/C's do best!!!!!!

[robert meldrum]

Are you using powder rather than liquid chemicals and do you live in a hard water area, as in addition to clearing the jets / filters you have to know the cause of blockages.

The breakdown of solution hose or dirt in the solution tank are other possible causes

As Colin says the answer is really obvious..............

remove / clear / replace but bevery careful to avoid scoring the jet surfaces or you will get sprays squirting at all angles.

If you ARE using powder make sure its fully disolved on hot water before adding to the solution tank.

[markpowell]

Your handtool is going to need a repair kit fitting, valve, springn and washer, usually not much more than a fiver and 2 mins work. As already said re the jet on the wand.
Mark

[carpetfitta]

thanx for your comments, confidence indeed.ill give it a go tomorrow.i dont use powder.but i will heed ur advice and have a go at fixing it.

i always try n flush the system after each use with warm water, both my solution and waste tanks get serious apres carpet cleaning time...

where can i get a repair kit?
thanx btw