[stuart howes]

hi all i have just got my tfr
can anyone tell my if your spraying on to say a con roof or some gutter how long is it ok to leave it on  before you have to wash it off   as it says on the can do not let dry on plastic or glass.
the tfr is 9.1  is this ok for plastic roofs  and frames or should i put a little more water in?
thanks    stu

[ronaldo]

Stuart, this is how we used to clean with tfr.

1, apply the tfr through a spray pump to top finial first and get that sorted.

2, then apply to 3 or 4 panels at a time.

3, with an old brush just go over what you,ve just done.

4, attatch hose to your pole and wash over and rinse then move on to the next panels.

Be carefull about getting to far infront of yourself as if its a hot day tfr will dry very quickly and leave you with more scrubbing.

Hope this helps you a bit.

Ron.

[Jason Atwell]

The tfr iv used was at a ratio of 9:1 as well, so to make life easier did it at 10:1, sprayed on to flat conserv roof 2 panels at a time left for 5 mins.

This was long enough to work on the algy, then cleaned and rinsed, probably could of done bigger areas but it was the first time id used it.

just give it all a good rinse when youve finished.

[Jason Atwell]

If you do get behind and the tfr drys, i found a quick re squirt of tfr loosens it all up again alot quicker than after the first application.

[tonyoliver]

whats tfr?
 sorry to sound

[russ_clark]

Traffic Film Remover.

Hi Stu

I mix 20:1 leave for about 5 mins then rinse off

Russ

I found the place we spoke about the other day
Still waiting for your email