I,m in the same boat. I was just going to start a new topic on the subject but Mr Bond beat me to it.
I think my water pressure as droped. I have a Low pressure membrane, a 40 40 RO. My tds going in is 100 and its comeing out at 13. Though I am probably producing 1ltr of pure water to 3 ltrs of waste. I could adjust the valve and produce the pure water a bit faster but my tds would be around 20.
Like Mr bond I have seen the b 70 LPM Booster Pump on Gardiners site, Heres their explanation of it.
To be used if your mains water pressure is too low for an RO system to work. We recommend this for use with a Merlin RO unit in areas with water pressure below 60psi. This will increase production rate (up to 225 litres per hour), lower water ratio and decrease TDS output (down to 001ppm depending on input quality). Most other 'booster' pumps for RO systems are not designed for use hour after hour and will burn out if used for anything other than occasional use. This booster pump is man enough to cope with the demands of a Merlin on full demand.
Specification
Stainless Steel Pump - Carbon & Ceramic mechanical seal
70 LPM
34 Metres Max Head
240 Volts
1.0 HP
Ports 1" F
Water Temp Max 60 C
Price: £152.00 (Excluding: VAT charge at 17.5%)
I had my pressure tested before I bought my Ro nearly a year ago. It was 45psi, I think its lower now. Would that booster pump make a diffrence?
Would that Booster Pump damage my Low pressure membrane?
If I bought it what would my tds be approxiamtley?
Its the same price as a couple of bags of resin so I have to work out if its worth my while buying it.
Nel.