[ben M]

need a connector to adapt on my RO 4040 (bottom screw)
Which one do i have to buy please?

Thanks

Ben

[ben M]

i said please 

[ben M]

something to fit this housing (bottom or top screw)

http://www.gapswater.co.uk/acatalog/AXEON-PVC-RO-Membrane-Housing-4--x-40---Champ-4040--2940.html

[bobplum]

when i looked straight away i thought 1/2 inch and then noticed on the pic it gives two options  and one is 1/2 inch

you can probably just get a copper 1/2 inch straight connection from a plumbing suppliers shop

[ben M]

i need 1/2 inch, which one do you use guys?

[ben M]

what do you use guys to connect your RO 4040 to the DI?

[Smudger]

Your link gives 2 options but you have mentioned 1/2 inch
You can get any 1/2 inch bsp/ bspf/gas threaded horsetail off eBay or hire shops that deal in pressure washers or industrial vacuums or hydraulic suppliers such as pirteks

HTH

Darran

[ben M]

Your link gives 2 options but you have mentioned 1/2 inch
You can get any 1/2 inch bsp/ bspf/gas threaded horsetail off eBay or hire shops that deal in pressure washers or industrial vacuums or hydraulic suppliers such as pirteks

HTH

Darran

Any link please Darran?

[ben M]

maybe Alex Gardiner can help?

[Alex Gardiner]

You would need one of these - http://www.gardinerpolesystems.co.uk/acatalog/john-guest-1-2-inch-push-in-fitting-to-1-2-inch-male-screw-bspt-thread.html
For use with John Guest tubing which is what I would recommend.

Or you could use these http://www.gardinerpolesystems.co.uk/acatalog/nylon-male-screw-thread-to-hose-barb-fittings.html you would need the 1/2" screw to 1/2" barb. This would be for use with 1/2" reinforced hose.

[ben M]

Thank you very much Alex