[JSMC]

Using my washer n it seems to have lost its pressure. No real kick from what it previously had. Machine is drawing water ok from wheely bin but other end poor when washing. No leaks on hose or fittings. Engine speed up and pressure up but very poor washing.

[JSMC]

help required people. I need to find out what to buy to ge tthis sorted. Also how do i find out pump type?

[Cliff perkins]

Only advice i can give is make sure its not sucking any air on the inlet.

[JSMC]

defo no air being pulled in. think it is defo valves from what i am being told

[Rob_Mac]

JSMC

I have just done a very quick look for Loncin pressure washers and the two I have looked at both have Interpump pumps!

I know of the make but cannot say too much because I have never really seen one in use.

What is it pumping like with nothing connected after the pump?. Have you tried this?

Give it over to the service people and let them put it right - that would be my solution!

Rob

 

[JSMC]

it sprays water out but pressure is low. find myself going over areas a few tmes to clean. Just wear and tear i reckon on pump it happens

[Matt Gibson]

Mate if you can get it over to me i can have a look for you.

[JSMC]

gonna order the parts and give it a go. Not much to these pumps. Have stripped down  pumps before in  factory i worked in. We had to strip them every few days and get them all cleaned down along with the control solenoids for opertaing them.

Just take my time and i should be fine.

buy the valves, o rings, oil and gaskets and give it a go.

[Matt Gibson]

You wont need o rings or oil. you shouldnt be touching the oil part of the pump. just the pump head which holds the valves/seals. also need to get the right valve kit and seal kit to match the pump.

[Cliff perkins]

Is it easy to change the valve seals etc.
Any special tools and videos i can watch ?

[JSMC]

i looke dup youtube last night and it looks easy enough if yer spanner savvy. Just use common sense it seems.