[wynne jones]

At least they've forgiven you for that incident when you did a burn test.   

[Chris Hawkes]

Sounds like you had a good time - hope you didn't damage too many brain cells over there.

I haven't had it laarge in a good while.  Always something to do early the next morning these days!

Chris

[M.Acorn]

Yeah,same here,can't really be seen out havin it large over here,due to the wife's job,so we really let our hair down,and yes my brain has only just started to feel normal,was getting worried that the,braindead feeling was permanent.
Glad to say feel fine now.
 

[Ricky M]

Mark, if thats ur new van then its time to get a TM dont you think.
unless you now have a TM and that is playing up.

You really have some luck when it comes to motor and machines !!

[M.Acorn]

Well it's a 54 plate so not brand new,but new to me,tm once I finish paying the loan for the last van    Feel like I am being tested sometimes,the pump I took out which was running erratically,and cutting out when I put my finger over a short length of hose that I use to drain the machine,got put back in,think I sold my soul again,just so I could complete the job,I had sprayed ultra pac on the really bad bit's,was an expensive natural fibre Berber,so it needed rinsing.Managed it by lifting the front of the machine,and banging it down,which seemed to give me 5 mins of use,before I had to bang it again.
Glad it was an empty eot.

[Ian Gourlay]

Mark

That happens to me every now and then . I have a return hose in my solution tank so I just turn down pressure at wand  such return hose until water flows sometimes takes two goes. 

If it is always happening need new pump.

I think I bought two new pumps  before I realised. Several years back now

[richy27]

Well it's a 54 plate so not brand new,but new to me,tm once I finish paying the loan for the last van    Feel like I am being tested sometimes,the pump I took out which was running erratically,and cutting out when I put my finger over a short length of hose that I use to drain the machine,got put back in,think I sold my soul again,just so I could complete the job,I had sprayed ultra pac on the really bad bit's,was an expensive natural fibre Berber,so it needed rinsing.Managed it by lifting the front of the machine,and banging it down,which seemed to give me 5 mins of use,before I had to bang it again.
Glad it was an empty eot.

mark used to have the same van as you   if you do upgrade to a tm in the future be carefull what tm you get as evenwith my spitfire  was like driving a bloody freight train.

[M.Acorn]

Yeah,with my big 17inch buffer in the back I notice the weight difference..
If i used my thumb,i could stop the pump running,was a miracle I got the job finished really.
Put the new one in yesterday,and it's full steam ahead again now,got lot's of work booked this week