[Klean07]

Does anyone know where I can get one that will fit into an ibc tank. The diameter of hole in top is 7ins.

[David Kent @ KentKleen]

Machine mart or screw fix are both pretty good for one. or a decent motor factors will be anble to get you a DRAPER pump, pretty good pump!
hope this helps

[Klean07]

I've tried most of these places and yes they all sell good pumps but all too big for my ibc.

[rz]

try ebay or a marine shop, bilge pump about £15.

[A & J Owen Window Cleaning]

klean just been looking at one today b&q gardinar its a pump with a hoselock fitting on it but its mains powered any good chech there website mate

[Ian Lancaster]

I've tried most of these places and yes they all sell good pumps but all too big for my ibc.

Not a problem

Just cut 4 radial slots from the lip of the screwed hole outwards as far as necessary to allow the pump to drop through.  Bend the plastic up and back so you can get the pump in, fold the plastic back again and seal with gaffer tape or plastic plumbing cement.

I did that 5 years ago - never any problems

[Klean07]

I've tried most of these places and yes they all sell good pumps but all too big for my ibc.

Not a problem

Just cut 4 radial slots from the lip of the screwed hole outwards as far as necessary to allow the pump to drop through.  Bend the plastic up and back so you can get the pump in, fold the plastic back again and seal with gaffer tape or plastic plumbing cement.

I did that 5 years ago - never any problems

I will try that mate thanks.