Clean It Up
UK General Cleaning Forum => General Cleaning Forum => Topic started by: clarkson on April 11, 2019, 04:24:43 pm
-
Hi guys
I have been asked to vac the sawdust out of a cnc room .
I was going to use ladders with someone footing or a small
Tower but today’s review no one is happy with that .
No room for mewps like a pop up
So has to be from the ground .
Thought about using the gutter vac
But does anyone know if you can get 2inch brush heads from anywhere to fit the vac tubes ?
Cheers
John
-
can't sat that I've seen any - however I did find a brush that fitted over 38mm and the outside diameter was a must fit inside a 2 inch tube - not ideal but does work
Darran
-
can't sat that I've seen any - however I did find a brush that fitted over 38mm and the outside diameter was a must fit inside a 2 inch tube - not ideal but does work
Darran
-
Mod note: if you wish to advertise please contact admin.
-
https://www.amazon.co.uk/SkyVac-111345691341-Internal-Brush-Pack/dp/B07CVCW3YP/ref=sr_1_16?keywords=sky+vac+accessories&qid=1556085598&s=gateway&sr=8-16