Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: JamesRoberts on October 24, 2018, 06:06:39 pm
-
Anyone got one of these?
How do you adjust pump psi?
Thanks
-
The alltec version .. the express uses this little regulator , more than likely same on mini
Its a low flow pump though so you mightn't do much turning down
https://www.worldwidecleaningsupport.com/spare-parts/water-pumps/200-psi-regulator-valve
-
Speak to Cleansmart...
It depends on what the original owners requirements were...they are built to specification
-
What type of pump is it? Some pumps are a set pressure and cannot be adjusted they just run at the maximum pressure they can produce
Take a photo, but if the pressure is meant to be altered then it will have a adjustment screw protruding out of the frame like this....
(http://www.cleanitup.co.uk/smf/1540542774_image.jpg)
-
^ whats the machine in the pic mick ?
anywhere they advertise a 220psi pump , its the aquatec diaphragm pump , the one i got with the alltec express has a demand switch ... but also a small regulator .
since then the demand switch burned up ... as they do .... so i just bypassed it ... and then with some more fooling around i removed the regulator .... so no it just runs full and continuous ... which its happy to do as its an internal bypass .
just to confuse things the 220 pump now has 250 on it ( slightly newer perhaps ) ...on woodbridges site
-
I’ve had this ages and never used it as it had a fault on one of the vacs but i’ve Fixed that. I’m going to give it a go as a wet vac with auto pump out.
With the recycle system I can put a solution line onto the machine poke it into the drain then as I work it will pump out the tank as I clean. I will Use my van water pump & heater for the solution supply
I just need to alter the inlet spade to take a 2 inch hose
(http://www.cleanitup.co.uk/smf/1540619338_967CAA98-5F5F-40EF-9901-6E8203F2E2E6.jpeg)
-
interesting apo idea , not the easiest machine to modify id say , but might work well