Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: neiljones on February 21, 2010, 05:46:58 pm
-
i'm after a transfer pump, its to fill 20 litre barrels from a 1000l ibc, so doesn't need to be super fast, (get v bored waiting for gravity to do it!) The ibc has a 6inch hole in top, has anyone got or know of a pump that drops straight in as I'd rather not be cutting up the ibc. any links would be great.
Cheers,
Neil
PS have tried search function but cant get a definitive answer!!
-
gardiners do a 50l per minute pump that will fit inside or do what we do and cut a bigger hole and get something more powerful regards alan
-
I use one of these to transfer from ibc to my van:
http://www.machinemart.co.uk/shop/product/details/cpe120-1in-self-priming-water-pump
They also do ones you can drop in the ibc i think but I've never tried one.
-
have a look on ebay for a bilge pump.
-
just go to an aquarium shop and buy one straight off the shelf with some lay flat hose .
-
Neil,
This is a problem we had when we were setting up WFP, you've got 4 choices that I know of
1. A bore hole pump (quite expensive)
2. A non submersible pump sat outside of the IBC
3. Cut a larger openning on the IBC
4. The one we opted for - buy a IBC with an 8" opening
Regards
Al
-
When I had an ibc I was lucky enough to pick up one that had a larger lid, but a guy that I did a work for picked up two that had smaller lids.
All we did with his was make two cuts in the top of the tank, one either side of the opening (approx 5-6 inches).
Then all we had to do was push the submersible pump through, did take a little bit of effort, plus I scuffed my knuckles, but we got it in.
Then all he had to do was make a hole in the lid for the pipe and tape up the cuts that we had made.
The pump just stays in there all the time.
-
cheers for all the help and advice, just be more convenaint if there was a pump out there that would drop straight in!
-
Try :-
"RULE" Bilge Pump. 1100 GPH / 4160 LPH
Model 270.
12volt
28mm discharge ( Pipe width)
6 amp fuse
Fully submersible.
No burn out when dry
Stainless Steel shaft
Available ebay
Great little pump and so quiet.
-
Thanks DavieT,
I think i've found the right one, ebay item 370326679285, Thing I don't understand though is do u just plug it into the mains or does it need wiring to a battery or something?
Cheers,
Neil
-
Hi,
It comes with 2 wires out of the unit.
I connected a length of 2 core auto cable to it and then to the respctive terminals of leisure battery in back of van
If you are good, you can use a connection to ciggy lighter.
You will need to buy a length of tubing sufficient to link IBC and containers.
Check Yellow Pages for marine suppliers etc.
If you cant find one, give me your email address and I can give you info of where I bought mine.
-
Try :-
"RULE" Bilge Pump. 1100 GPH / 4160 LPH
Model 270.
12volt
28mm discharge ( Pipe width)
6 amp fuse
Fully submersible.
No burn out when dry
Stainless Steel shaft
Available ebay
Great little pump and so quiet.
http://cgi.ebay.co.uk/Rule-type-1500gph-bilge-pump-12volt-29mm-outlet-New_W0QQitemZ130354301689QQcmdZViewItemQQptZUK_CarsParts_Vehicles_BoatEquipment_Accessories_SM?hash=item1e59b8caf9
Wouldnt this one be faster,
He also sell window cleaning supplies aswell.
-
Another point!
You will need a torpedo type on/off switch to switch off the pump when your containers are close to being filled up.
-
I think that what I'm really after then is a similar sized and specked pump, that runs of a normal plug (As I'm tranfererring water in my garage rather than in a van) so i wont need a leisure battery or special on/off switch. the search continues! ::)
Neil
-
Go to machine mart, they have loads of pump out, so you can have a look and see which one will fit. ;D
-
I have two of these:
http://www.amazon.co.uk/Draper-35463-Submersible-Water-Pump/dp/B0001K9TDI
They even have a bracket on the side to fix the float switch in the 'on' position so you can control the pump with a simple 'on-off' switch in the power line.
Cutting a slot in the top of the IBC is perfectly OK - just seal it up with gaffer tape afterwards.
Mine are both several years old and have been totally reliable.
-
from monday
12 quid from lidl's
3 year manufacturer's warranty aswell, just keep the receipt and lidls will give you your money back if it breaks
-
Thanks for all your help.
Craig - has your ibc got a six inch opening at the top?
cheers