Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: A & J Owen Window Cleaning on January 31, 2010, 06:15:34 pm
-
just cranked me new ro system and it working great the only thing thats a problem is that the tds reading is the same as from the tap whitch is 320 i have purged the system any advice i have followed the instructions correctly cheers mates
-
Not an expert here and depends on the system but have you left the flush valve open?
and are you checking the pure or the waste ?? i only say this as the 1st system i had i used the waste not realising the tiny trickle coming out the other pipe was pure and the fast flowing pipe was waste! :-[
Darran
-
just cranked me new ro system and it working great the only thing thats a problem is that the tds reading is the same as from the tap whitch is 320 i have purged the system any advice i have followed the instructions correctly cheers mates
you got a 4040 ro
-
needs to be flushed for hours, and what ever you do, do not connect to the resin as will cost a small fortune, few hours then test,
-
shut the waste tap then turn it anti clockwise 1/4 turn then test if no good turn another1/4 then test so on .
DO NOT shut the waste tap tight just till you feel it touch .
-
yeh i will try that the flow pipe a bit tricky how long does the pure water come through then
-
a few minutes
-
will crank it up again in a sec i hear some where online there was a chemical u can use to bring the tds reading down to 2 any advice mate
-
never herd that one , if you have the water on full max presure , the water should be going in the tank at around 6/7 tds . then when you get to the job it goes through the di to the hose.
tap/pre filters/RO/tank. that order then............... tank/di/hose.
-
Makesure you have it plumbed in the right way round,you could have the waste water going in the tank that`s why it looks like you have a high reading.It dosen`t have to be flushed that long before the reading comes down.
-
plumbed in ok orange hose waste and blue pure aint it
-
plumbed in ok orange hose waste and blue pure aint it
Who know`s,the colour of you hoses means nothing to me i`m afraid it needs to be plumbed in correctly so tht the good water is going into the tank and the waste water is going down the drain "simples".
-
its plumbed in ok m8 who does cheap baffle tank do you know
-
is it working now
-
Check your di tube.Carefully unscew it and see if it is not damaged.Mine was when I got it last week.
If there isnt a perfect seal your reading wont be 00.
Steve.
-
have tried all these still the same run it today for 2hrs gettin peed off with it now still 330 tds tried flow tap shut and open and just betwen