Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: ftp on January 05, 2010, 07:57:46 pm

Title: slx marker
Post by: ftp on January 05, 2010, 07:57:46 pm
Well, fed up with my extending marks wearing off (tape, paint, even etch marks) I have finally found a way of marking my pole sections so that they don't extend too far and fly out of the clamp on a three story property.
I have drilled through the pole with a small drill bit on the top of the pole shaft. Easy to spot, doesn't wear off - as soon as I see it I push the shaft back into the clamp another centimetre. Seems to work ok so far.
Title: Re: slx marker
Post by: pingu on January 05, 2010, 08:20:39 pm
You need to do this all the way round..then you'll see it all the time...

Dave.
Title: Re: slx marker
Post by: cas100 on January 05, 2010, 08:34:45 pm
better still run a hacksaw around the top of the clamp just enough to cut in to the alluminuim pole then pull out and paint in the cut with red paint ,job done can not wear off now. ;D
Title: Re: slx marker
Post by: thewaterwizard on January 05, 2010, 08:45:53 pm
i don't think so its a carbon fiber pole !!
ive taken my markers off and can still see were they were so no prob
Title: Re: slx marker
Post by: cas100 on January 05, 2010, 10:40:56 pm
i think you will find it dose work ive done it on carbon,just use a new blade.