Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: wizard on November 29, 2009, 09:52:49 pm

Title: Stiil need help with di
Post by: wizard on November 29, 2009, 09:52:49 pm

Putting together a new ro unit but cant seem to see into which plug the ro water enters the di , No arrows. Its a 10 di same as the ro man one it has inlet and outletm but which on is it ,Hoe can I tell.

Title: Re: Stiil need help with di
Post by: Mr Bungalow on November 30, 2009, 02:00:44 pm

Hello Wizard,

You normally fit RO outlet point to the inlet point on the DI vessel.

As the water comes through the outlet point on the DI vessel it will be pollished.

I hope this helps at all.

Kind regards. :)

Title: Re: Stiil need help with di
Post by: Ian Lancaster on November 30, 2009, 06:03:15 pm

Hi Wizard,

The inlet water into the DI enters around the outside of the cap, travels down through the resin and into the bottom of the riser (the central column) and rises up (see?) to the top and exits through the centre of the cap.

Take the cap off, connect a water supply to one of the holes and see which bit of the cap the water comes through, if it's the outside you're on the right track, if it comes down from the middle you need to feed into the other hole.