Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: Paul Simpson on October 09, 2009, 04:28:18 pm
-
Hi Guys
Got a shop floor to do Sunday made up of carpet tiles with some areas it feels like its laid on board, not particularly dirty apart from a few gum marks plus they had a burst pipe and subsequently water leaked onto the floor and has left a few large water marks.
Is there something specific I should use on the water marks, or is it more likely to just come out in the normal clean?
And what about removing gum on bitumen tiles? Citrus gel in moderation?
Cheers
Paul
-
Is it polyprop? Be careful with the solvents on the gum. Check for bitumen backing - if it has this, heavy use of solvents will land you a big problem.
Take some stain absorbent compound with you for anything you think might wick back. Consider buffing it after extraction. Might also be an idea to use an oxidiser during or after the clean (may sound mad but it can prevent or correct yellowing on polyprop.)
Best of luck.
-
Try and get the gum up as fast as posible after you have put the gel on also wouldnt overwet the tiles as it might cause the board to warp..
-
Carpet tiles will probably be polyprop/bitumen backed
For the gum I would use prochem citrus gel and for the water mark I would pre spray with prochem browning prescription and rinse extract with prochem fibre and fabric rinse
-
Cheers gents.
Knew that solvents & bitumen don't mix, that's why I was asking if you guys use anything else that works well.
Have everything that Gerry mentioned so will go with that.
Cheers
Paul