Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: rz on September 26, 2009, 04:11:40 pm

Title: omnitrolley flow rate
Post by: rz on September 26, 2009, 04:11:40 pm

hi does anybody know if you can adjust the flow rate on a omnitrolley 50 classic as it is useing way to much water.

thanks

Title: Re: omnitrolley flow rate
Post by: p1w1 on September 26, 2009, 04:19:12 pm

fit a tap to it mate from the hose pipe that comes up from underneath the trolly you can then adjust the flow rate using that . I can post a pic up to give you an idea.

paul

Title: Re: omnitrolley flow rate
Post by: rz on September 26, 2009, 04:22:07 pm

thanks, i know what you mean, i did,nt know if you could turn the pump down...

tap is is then,
thanks a lot

Title: Re: omnitrolley flow rate
Post by: leapstallbuildings on September 26, 2009, 05:04:31 pm

The Omnitrolley classic comes with a tap already fitted though - or did you buy yours second hand and it may have been adapted?  Trying to remember butr I think it worked on the same principle as their van mounts i.e. a fully open tap = no flow tro pole and a fully closed one = full flow to pole (I think the tap was fitted on the return to tank pipe so increases flow when closed).

Title: Re: omnitrolley flow rate
Post by: Glyn H on September 26, 2009, 06:03:06 pm

Quote

The Omnitrolley classic comes with a tap already fitted though - or did you buy yours second hand and it may have been adapted?  Trying to remember butr I think it worked on the same principle as their van mounts i.e. a fully open tap = no flow tro pole and a fully closed one = full flow to pole (I think the tap was fitted on the return to tank pipe so increases flow when closed)

Spot on  ;D