Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: m b shaw on September 13, 2009, 07:33:40 pm
-
just had quote to move my pro 5 reach and wash system to a new van,this is to speedline floor as well.the quote was 1100 pds inc vat.now i m no diy man but it can t be rocket science can it,iv e got loads of mates who are mechanics/engineers/plumbers etc.do i need to be careful with any specific thing or is it fairly straight forward,hope someone can advise. cheers mick
-
look at it as a jigsaw puzzle.
its not like much can go wrong in fitting it, whats the worst that can happen? you forget to secure a fitting and you get wet?
where in the country are you? some friendly chap may offer some assistance.
-
i m in notts,thanks for reply it s more the tank fitting than anything but it s right what you said if we treat it like a big jigsaw we might be o k. cheers mick
-
are you moving it into the same type of van?
-
yes frm transit to transit,only differance is new van is medium wheel base and medium roof instead of short wheel base. cheers mick
-
have a look at where the current system is bolted, most likely through the chassis rails...find the same location on the new one, and you should be in luck.
mine is an swb transit, can take pics of how its mounted underneath if you like?
-
Ask your local garages if they would be happy to fit vehicle tank for you, poss. £150.
Not many places do speedlining though, likely cost around £500 if that is what you want.
-
Ask your local garages if they would be happy to fit vehicle tank for you, poss. £150.
Not many places do speedlining though, likely cost around £500 if that is what you want.
I agree. To fit a tank is a £150 to £200 job.I've just had a leisure battery wired up up in one of my vans and that was£60,i bought the battery though. Speedlining in my Traffic was £550 i seem to remember. Basically, Protektacote the floor yourself and get a garage or you and a competent mate to fit the tank. Probably get out of it for £300ish.
-
thanks concept and dd i ve just rung a mate who s an engineer and he said bring it round and i ll sort it,so thats a good start,as for the speedlining i reckon if i buy the stuff i can get a couple of my lads to apply it. thanks again for help. cheers mick