Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: kenny jones on April 19, 2009, 11:58:16 am
-
I left van with employee for first time yesterday...............
he telephoned me just as i was walking in to the footie stadium and said things arent working, after he used all water.
Anyway i blooby peed of the pump wont work and the controller tries to power it but it just works for a second and i keep getting an erorr code de. battery ok i ythink and water in mahine.
please help or link for streamline insructions.
-
bump
-
:-\ >:( it works for a hile if any got the streamline insructions need check error code... i will order another pump!!!
-
:-\ >:( it works for a hile if any got the streamline insructions need check error code... i will order another pump!!!
where are you based m8 if youer near me pop round, I'm in bedford
-
i am in teeside to far but thankyou very much for offer.
-
Is it a digital controller?
-
yes it is
-
code de flashes up
-
I dont know if this'll help or if its a different controller, but have you got an 'up' arrow button and a 'down' arrow button on it?
-
yes :) and a side arrow
-
Well, I wonder if the cutout is set too sensitively.
Go out to the unit and turn the thing on, then AT THE SAME TIME press BOTH the up and down arrows together. You will then be able to adjust the necessary setting, just try turning it up by 15 points perhaps, you need to play around with it to see how well it runs.This may work, if not try playing about with the settings. If you normally run two guys off it an dthen you let matey go out on his own then that may have something to do with it.
But remember your NOT trying to adjust the point at which the pump cuts out, your adjusting the other setting, so you have to do BOTH buttons TOGETHER.
Matt
-
thanks matt i getting somewhere!!!!
the pump is turning fine i just still get error message occasionaly.
if anyone got instructions or a link be very helpful thanks.
-
is this unit the one from vari tech , 3 buttons and blue face ?
Rich
-
thanks matt i getting somewhere!!!!
the pump is turning fine i just still get error message occasionaly.
if anyone got instructions or a link be very helpful thanks.
Possibly try turning the actual setting down, so the water flows a little slower, I had the same problem as you mate...it was caused by insufficient tolerance BETWEEN the flow rate and cut off setting.
Its a case of playing around with it and finding out whats best.
My cut off setting I think is set at 85 but I run my pump from anything between 40 and 75
-
it from streamline 3 buttons and blue face.
I think it is a case of messing on with it i had enough now :) :) ;)
it just means a van of road morrow and i stowed under...
thanks for help im sure i will crack it morrow.........
instruction link ;D would be superduper
-
i had the same problem , the best thing to do is to press the up and down buttons together , keep them hold until the word CAL comes up , then press the up button until it gets to 99 , then press the across button , the word SET should come up , this should sort things out for you , then all you need to do is run the pump and find your flow rate , i use it on 75 with the blue fan jets from vari tech and 100 M of 6mm microbore .
Hope this helps
Rich P @ F
-
That should sort it...now
-
THANKS VERY MUCH FOR ALL YOUR HELP..... PUMP IS OK ;D ;D ;D THANKS TO YOU LOT.
-
and tell your man to kepe his fingers off it in future ;D ;D ;D