Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: poole bay on February 08, 2009, 07:44:40 pm

Title: flow controller problem
Post by: poole bay on February 08, 2009, 07:44:40 pm

i have a controller that pulsates any one no why it does that i have it on number 2 any more and it goes on and off  ???

Title: Re: flow controller problem
Post by: Dennis-Taylor on February 08, 2009, 08:27:42 pm

Sounds like a flat battery

Title: Re: flow controller problem
Post by: eclipse on February 08, 2009, 08:34:10 pm

could it be the "dead end" setting that is set too low?

what controller is it?

Title: Re: flow controller problem
Post by: poole bay on February 08, 2009, 10:19:52 pm

its the digy one where you press the button

Title: Re: flow controller problem
Post by: Nathanael Jones on February 08, 2009, 10:20:50 pm

Its either the dead end set too low or your pressure switch is still wired in.

Title: Re: flow controller problem
Post by: poole bay on February 08, 2009, 10:28:34 pm

what does it mean dead end mate

Title: Re: flow controller problem
Post by: LWC on February 08, 2009, 10:38:47 pm

Hold down + and - and you should see a letter or a number, then hold them down again and it will start flashing, you will have 1 - 9 and A - E settings, this is just the pressure setting, just have a play around until it flows constantly on your setting, with the pole connected. When your done turn off and back on.

I have mine on A.

Its building up pressure and turning off too quick, its just a setting, nothing to worry about, just needs a bit of fine tuning  ;).