Clean It Up
UK General Cleaning Forum => General Cleaning Forum => Topic started by: drive surgeon on October 02, 2008, 05:57:16 pm
-
hi guys, ususally i use a small fsc on decking but im quoting a massive area of decking that is like an ice rink when you stand on it, can i use the big whirlaway on it at full bore or would i be best with smaller one with less pressure? could i turn down revs on machine?
-
hi, i use one without the caster wheels.and i turn down the revs of my machine down.and then sweep over with the fan jet.
-
Hi,
On dirty decking I always use the Tec Clean fsc and then go over with the small wall cleaner.
All on full power. It can make the timber feather a bit but the finish is very good.
-
think it will be ok on full myself as it will give uniform finish.
-
I use the tech clean set up at 2/3 to 3/4 pressure. no probs but have splintered old decking at full power.
just start low and you can always increase it if required.
-
it would be best if you can use hot water at a lower pressure but if you only have cold then i would sugest treating the area first with a algae remover and then going over with the fsc but using bigger jets this way you will still have the water flow but the pressure wont damage the wood.
-
cheers trev!
-
hi,
will the hot water do anything to the grass and plants.
-
it will make them lovely and warm!
well some one was going too!! :)
-
hi,
will the hot water do anything to the grass and plants.
the water itself wont do any harm but if you leave the hot pressure hose trailing along a lawn then it can burn the grass.
-
dont worry just using cold water this time. 8)