Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: John Gregory on June 28, 2007, 01:26:27 pm
-
How do you lads with truckmounts use ultimate master as a pre spray thinking of trying it on some barstools
-
i use Ultimate Master as a rinse, but use a fabric pre spray first
-
Thanks for the replie Colin
How much do you put in your solution container and what do you set the GPH dial at, also why do you use it instead of a acidic rince , or formula 90 etc I was hoping to use it to clean about 50 bar stools in a local hotel , not to badly soiled
-
I use it as a prespray sometimes, not a bad product.
Dene
-
Why would you use ultimate as a rinse
-
Dene
How do you mix it when using it as a pre spray? How product do you use in 5 litres of water
Thanks John
-
I cant remember without looking at the label but i think you dilute to 10gm a litre, so 50gm for 5 litre pump up sprayer, should tell you on the label.
Make sure you mix in hot water.
Dene
-
Dene
On the label it says one scoop [ 50g ] to 30 litres of water mix in solution tank then spray carpet with handtool or wand . I was hoping to use it like a conventinal pre spray , spray bar stools , agitate with mit or brush then extract with truckmount using just water
Thanks John
-
It works on black top (dwell time)
Len
-
Len
How do you mix it , how much product to 5 litres of water
-
John, my bad, i was wrong earlier, looked on packet and it says 10g per 5 litres
Dene
-
i have used ultimate master for quite a few years with very good results although it is a non buffered chemical and it loses its strength of ph as soon as it is sprayed on to the carpet surface
-
John
Cant remember only had there samples, but followed instructions, it get the thumbs up from me!
Len
-
Good product .................the original was a bit abrasive, but I think that was remedied
-
Carpetguy
does that seem right 10g to 5 litres of water
Thanks John
-
Long time since I used the product, but I recollect it was comparatively expensive to use, so the rate might be higher.
-
Just looked at the web site.........................50 g / 25 lts !!!!!!!!!!!!!!!!!!!
rob
-
Carpetguy
50g/25litres is when you are using it in a solution tank of a machine I was hoping to use it like a tradional pre spray , then extract with truckmountl
-
Works well for me when pre-sprayed down first using a pump type sprayer (do not always like putting powdered chemicals in portable). Using a prochem powder scoop 15gm I fill just over half with Ultimate Master to 5Ltrs water.
Nigel.