Clean It Up

UK Window Cleaning Forum => Frequently Asked Questions & Useful Resources => Topic started by: Simon Carter on February 18, 2007, 12:56:40 pm

Title: RO TDS when new
Post by: Simon Carter on February 18, 2007, 12:56:40 pm

I changed the filters, membranes & DI resin this morning in an RO-Man RO 300 that I haven't used for a while. It's at home & I'm in my office, but when I left it the TDS before the resin was about 100. My tap water is hard. Does it take a while to settle?. Will it be ok when I get home, or do I have another problem?. If so, what?

Title: Re: RO TDS when new
Post by: TERRY AB on February 18, 2007, 01:58:52 pm

Yes, you should allow the unit to run about 2 Hours
before the TDS comes down.
If possible it would have been more economical to connect the
DI when the TDS Values have come down to the value you usually get,
as you arent using this water yet are you ?

Terry

Title: Re: RO TDS when new
Post by: Simon Carter on February 18, 2007, 02:46:27 pm

Thank you Terry. I'm off home now to check. I'm not as yet running the water throught the DI as I appreciate that as I left it, it will just eat the resin up.