Clean It Up

UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: Wozza on December 01, 2006, 09:29:00 pm

Title: some advise please
Post by: Wozza on December 01, 2006, 09:29:00 pm

I have installed my own  R O unit today to my van, installation went well. ;D

However, I have 2 questions on  ???

How much salf softner do you add to the Softner tank vessel..EG: half way up the tank all the to the top ?

Also the DI vessel Same question really how much resin do I add to the tank...half...full ?

I don't have any instructions on how much to add otherwsie I would not asing lads. I new to purifying as I have been buying my water for a while.

Thanks for any help. ;D

Title: Re: some advise please
Post by: craig jwc on December 01, 2006, 11:37:21 pm

I only use DI and fill it about 3 quarters full.

Have to wait on someone else to post on softener

Craig

Title: Re: some advise please
Post by: seanmcshane on December 02, 2006, 06:23:55 am

is the salt vessel a clear blue container about 10 inches high.
If so, fill it to top with your salt and when salt has dissolved in water flow, let it run on for a few minutes before switching your hoses back into their correct position.
Is your DI vessel the blue aqualung type vessel?
If so, fill to top with resin.
I cut a peice of garden hose (about 6 inches) and I place this in the top of the tube in the centre of the vessel so no resin gets in.
I got a football training cone and cut off the top to form a funnel. This goes over the hose that is sitting in the tube and fits perfectly just inside the rim of the vessel. I can then just pour in the resin.

Title: Re: some advise please
Post by: Wozza on December 02, 2006, 08:34:22 pm

Thanks alot boys.

That was a big help on both accounts.

I even took your advise and used a football cone to get the resin into the tank ! ;D


Thanks again

warren