Clean It Up
UK Floor Cleaning Forum => Carpet Cleaning Forum => Topic started by: matt jones on September 21, 2006, 09:48:06 pm
-
I was wondering if someone could give me some advice recently noticed that my my wand has a slight leak in it. The leak is coming from where the male connector screws inn i have tightened this up but with no improvement the wand is only 1-2 months old any suggestions would be appreciated.
regards
matt
-
check for any cracks, these can go if overtightened or dropped?
Darren
-
checked mate i cant see any, will check agian tom though any ways round fixing this kind of leak as it's really starting to annoy me on the job?
-
PTFE tape from plumbers merchants. If there arent any cracks as mentioned above then wrap this around the threads and re-assemble-should stop it. ;D
-
ideal that's what i was thinking of doing mate thanks alot
-
Matt i use it on every thread. Wind it on opposite to turn-if ya know what i mean, then it bites properly. ;D
-
i find plumbers mate much better than tape