Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: tom20001 on October 10, 2017, 11:14:06 am
-
Ive been doing this for 5 years and now all of a sudden the di has started leaking badly enough. Its leaking at hoselock fittings but if also seems to be coming out of the threaded piece that the hoselock fitting clips onto that is inserted via thread into di vessel
Your experiences lads? Help
Ps ive tried the obvious stuff like a new hoselock fitting and re taping the threaded piece that inserts into di vessel
Also the system seems like its over pressurised
-
Could it be a cracked fitting or housing?
-
Could it be a cracked fitting or housing?
Im going to inspect it later simon but nothing seems cracked at all.....system seems like way too much pressure in it
Ive a twin di an both are leaking now. One badly one a little
-
It does sound like you have a hairline fracture where the hozelocs fit in , i have had a coulpe do this to me .
-
It does sound like you have a hairline fracture where the hozelocs fit in , i have had a coulpe do this to me .
Not on the hoselocs but on the insert piece? Could it happen to a couple at the same time? Or within a week of each other?
Thanks
-
I've had this
For me it was the big rubber washer that had fallen out of the screw top.
-
It does sound like you have a hairline fracture where the hozelocs fit in , i have had a coulpe do this to me .
Not on the hoselocs but on the insert piece? Could it happen to a couple at the same time? Or within a week of each other?
Thanks
I mean the main black lid on the DI , theres a few different ways people set them up , so if you imagine that lid with no fittings on it at all , it would just have 2 threaded holes , around these are where you get the hairline fractures , normally due to over taping or over tightening , also you get 2 types of plastic used , 1 is dull and almost rubber like , the other is very shiny and is a lot more brittle , this one is more prone to do it .
-
Turn your pressure down? ;D
-
It does sound like you have a hairline fracture where the hozelocs fit in , i have had a coulpe do this to me .
Not on the hoselocs but on the insert piece? Could it happen to a couple at the same time? Or within a week of each other?
Thanks
I mean the main black lid on the DI , theres a few different ways people set them up , so if you imagine that lid with no fittings on it at all , it would just have 2 threaded holes , around these are where you get the hairline fractures , normally due to over taping or over tightening , also you get 2 types of plastic used , 1 is dull and almost rubber like , the other is very shiny and is a lot more brittle , this one is more prone to do it .
If it is the case just buy a new di vessel head. Gardiners do them and they are only about a tenner.
I've never really liked using hoselock fittings on them. I know a lot of people use jg push fit, I've always preferred geka brass fittings for 1/2 " hose.
https://www.waterirrigation.co.uk/hoses-and-accessories/geka-and-professional-irrigation-products/geka-and-claw-lock-couplings/geka-threaded-coupling-19mm-3-4-male.html
and
https://www.waterirrigation.co.uk/hoses-and-accessories/geka-and-professional-irrigation-products/geka-and-claw-lock-couplings/geka-hose-tail-13mm.html