Clean It Up
UK Window Cleaning Forum => Window Cleaning Forum => Topic started by: C.C.S. on August 07, 2017, 06:46:11 pm
-
(http://www.cleanitup.co.uk/smf/1502127505_20170807_181859.jpg)(http://www.cleanitup.co.uk/smf/1502127518_20170807_181905.jpg)
Hello everyone. I'm in a little bit of a problem .I've changed my membrane today and when I've turned the water on the bottom part of the housing came off under pressure. No mater how tight are the brackets it's comes off . Visually I can't find anything wrong .The only thing I suspect is the black plastic bottom cap it might me to loose .But never had problems before. So not sure what to do from here .Thanks
-
Have you put the washer back on?
-
It looks as though you've got the bracket in the wrong place. The bracket is concave on the inside, one edge fits the 'bell' on the housing, the other fits in the channel in the end cap so when you tighten the bracket it pulls the end cap and housing together
-
Have you put the washer back on?
Yes . I did . I 've put everything as it was. Even put back the old membrane to see if there is any diference
-
I take it you have seen Ian 's post and got it sorted , i always laugh when i see people do this with a 4040 ;D
-
It looks as though you've got the bracket in the wrong place. The bracket is concave on the inside, one edge fits the 'bell' on the housing, the other fits in the channel in the end cap so when you tighten the bracket it pulls the end cap and housing together
I've just been to the van. You're wright .I haven't been paying attention when I took it off. Thank you very much .That saved me a day or two of work
-
Looking at the pic , you have made the same mistake with the top bracket too !!!
-
Looking at the pic , you have made the same mistake with the top bracket too !!!
yes i know . I feel quite stupid .
-
Dont worry , the secret is safe with me , and the rest of CIU ;D